Brian, The traceback is usually in the reboot message....You can also try this....Upgrade to 12.3(8)T...this just came out last week. It has a nice new feature....if the router crashes, it stores the full crash on system flash. On a 7200 with PA-VXC cards, I have yet been able to find a version of IOS that is optimized for VOIP. I ran 12.2(x) and could never get DTMF tones to work...I upgraded to 12.3(x) and fixed the DTMF tones but now all FOIP calls fail.
-- Harold Workman CCNA, CCNP Cytel Communications [EMAIL PROTECTED] Ph. 281-449-4000 x3098 Quoting Brian Wilkins <[EMAIL PROTECTED]>: > A traceback is not possible. The best thing I can show everyone is the reboot > > message. The logs got obliterated when the Asterisk server started up and the > > best we can imagine, sent an invalid "code" to the router. We are going to > set up a small test subnet here and bounce around on the router to see what > is the problem. The Cisco 7200 router uses the IOS that is optimized for > VoIP. The server caused our fiber card to burn up and now we have to replace > > it. > > On Yaum al-Arbi'a 12 Jumaada al-Awal 1425 05:42 pm, Harold Workman wrote: > > As far as loosing the configuration...the only reason I could see that > > happening is if you either are doing one of the two... not saving the > > configuration...or you have the configuration register set to something > > like 0x2142. look on show version for the configuration register. it > > should be 0x2102. And again, i would look for tracebacks...it could > > either be a memory issue or a bug in the IOS. But you will know if you > get > > console access to the router as u bring up the asterisk... > > > > > > > > > > ----------------------- > > Harold Workman > > CCNA, CCNP > > Cytel Communications > > [EMAIL PROTECTED] > > Ph. 281-449-4000 x3098 > > > > [EMAIL PROTECTED] wrote: > > > IOS version 12.xx > > > > > > As far as a traceback, that's going to be difficult now since we've > > > removed it from our switch and brought it back here to the office for > > > testing. When we test it tomorrow or later in the week, I'll see if > > > it crashes again in a test setting and try to get a traceback to the > > > list. > > > > > > It is a Cisco 7206 and all the computers connect via IP. > > > > > > On Yaum al-Arbi'a 12 Jumaada al-Awal 1425 05:16 pm, Harold Workman > > > > > > wrote: > > >> [EMAIL PROTECTED] wrote: > > >>> Hi, > > >>> We are having an issue here. It seems that whenever we initialize > > >>> Asterisk on our network, the router that the Asterisk server is > > >>> connected to (Cisco 7200) crashes and loses it configuration. This > > >>> has happended five times and each time we have tested it, it is > > >>> always when Asterisk starts up. Has anyone else seen this problem? > > >>> It is very odd because this is a very good router and we had the > > >>> Asterisk server on an exact same router but different network before > > >>> and it did not cause a crash. We have gone through two different > > >>> Cisco 7200 series routers and both exhibited the same problems. Any > > >>> clues? Thanks - > > >>> > > >>> > > >>> -- > > >> > > >> Brian, > > >> > > >> > > >> Did you log into the Cisco console and watch the cause of the crash? > > >> You should be getting a traceback. Or after the router crashes and > > >> reloads look at show version. Could you give a little better > > >> explanation of your network as well. Are you conecting to the 7200 > > >> via serial or ip? sip? > > >> > > >> > > >> ----------------------- > > >> Harold Workman > > >> CCNA, CCNP > > >> Cytel Communications > > >> [EMAIL PROTECTED] > > >> Ph. 281-449-4000 x3098 > > >> > > >> _______________________________________________ > > >> Asterisk-Users mailing list > > >> [EMAIL PROTECTED] > > >> http://lists.digium.com/mailman/listinfo/asterisk-users > > >> To UNSUBSCRIBE or update options visit: > > >> http://lists.digium.com/mailman/listinfo/asterisk-users > > > > > > -- > > > > _______________________________________________ > > Asterisk-Users mailing list > > [EMAIL PROTECTED] > > http://lists.digium.com/mailman/listinfo/asterisk-users > > To UNSUBSCRIBE or update options visit: > > http://lists.digium.com/mailman/listinfo/asterisk-users > > -- > -- > Heritage Communications Corporation > Melbourne, FL USA 32935 > http://www.hcc.net > _______________________________________________ > Asterisk-Users mailing list > [EMAIL PROTECTED] > http://lists.digium.com/mailman/listinfo/asterisk-users > To UNSUBSCRIBE or update options visit: > http://lists.digium.com/mailman/listinfo/asterisk-users > ---------------------------------------------------------------- This message was sent using IMP, the Internet Messaging Program. _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users