>From what I have seen so far on this list if you are running a version of CVS-Head prior to release of Asterisk 1.0 then you should keep it and not try to change or upgrade it. It would appear that there are a lot of recent changes that may break if you try to upgrade to current CVS-Head, and conversely that 1.0 is missing a lot of functionality that was present in August / September CVS-Head.
Craig ----- Original Message ----- From: "Simon Brown" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]>; "Asterisk Users Mailing List - Non-Commercial Discussion" <[EMAIL PROTECTED]> Sent: Monday, October 11, 2004 2:16 PM Subject: RE: [Asterisk-Users] Error starting I have been running Asterisk happily for many months and I was trying to upgrade from CVS-HEAD-08/13/04-10 Simon Brown -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of el Flynn Sent: Monday, 11 October 2004 16:09 To: Asterisk Users Mailing List - Non-Commercial Discussion Subject: Re: [Asterisk-Users] Error starting Simon Brown wrote: > I have just downloaded V1.0 from CVS and when I try to start Asterisk > (after compiling and installing) I get this error: > > Oct 11 15:51:29 ERROR[1076241024]: chan_zap.c:6205 mkintf: Unable to > get parameters Oct 11 15:51:29 ERROR[1076241024]: chan_zap.c:9134 > setup_zap: Unable to register channel '2' > Oct 11 15:51:29 WARNING[1076241024]: loader.c:334 ast_load_resource: > chan_zap.so: load_module failed, returning -1 > == Unregistered channel type 'Tor' > == Unregistered channel type 'Zap' > Oct 11 15:51:29 WARNING[1076241024]: loader.c:429 load_modules: > Loading module chan_zap.so failed! > > Does anyone have any ideas what is wrong? > Did you upgrade to V1.0, or is this a brand-new installation? New install: Do you have any digium cards on the machine? If not then that's probably why it's throwing up the 'Loading module chan_zap.so failed' error. If you're going to run the * box without any of the digium cards then you need to add noload => chan_zap.so in /etc/asterisk/modules.conf New install, have digium card: Perhaps your box isn't recognizing the card due to an IRQ issue? run the "dmesg" command and make sure there's something in the output that shows your box recognizes the existence of the card. Perhaps posting a bit more information about your setup might help. Cheers Flynn _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users