On Thu, 28 Oct 2004 at 14:08, Louis van Dompselaar wrote: > It's already at devices=2 but that doesn't make a difference.
Sorry, I was looking at the wrong place and drawing the wrong conclusions ... > I think chan_capi sees the C4 as one single device with four > controllers. A "device" corresponds to a B-chanel in capi.conf. See the capi.conf form chan_capi source tarball - it uses devices=2 for BRI lines, and devices=30 for PRI lines. So the C4 appears to chan_capi as 4 controllers with 2 devices each. You need to set up a separate interface section for each "controller" that is actually in use, and just skip the rest: [interfaces] ; The first controller msn=... ... controller=1 devices=2 ; The second controller msn=... ... controller=2 devices=2 > Contr1: 2 B channels total, 2 B channels free. > Contr2: 2 B channels total, 2 B channels free. > Contr3: 2 B channels total, 2 B channels free. > Contr4: 2 B channels total, 2 B channels free. "capi info" reports all the CAPI devices that exist in the system, but that doesn't mean it is really using them all. If you start Asterisk in verbose mode "asterisk -vc" , you should see a warning like this for every unused CAPI controller: Oct 28 15:41:04 WARNING[1076791936]: chan_capi.c:2786 load_module: Unused contr2 This is what I get on a system with a C2 card where only one of the two controllers is configured in capi.conf. cu Reinhard _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users