On Tue, 23 Nov 2004, Asterisk wrote: > At the moment, I have the following working scenario: > > isdn30B->(1)te410p(2)->merdian(B) > isdn30A->meridian(a)->te410p(2) > > IOW, two isdn30 lines, one going to * span 1, the other going to the > meridian (pri card a), which then is connected to * by pri card (B) into > span 2 > > What I wanted to do was > > isdn30B->(1)te410p(2)->merdian(B) > isdn30A->(3)te410p(4)->meridian(a) > > IOW two ISDN30 lines, one going to * span 1, the other to * span 3. * is > linked to the meridian card A by span 2 and card B by span 4. > > However: * reported everything was fine except span 4 - the D channel > kept going up and down, and I got a Clock Controller error and red alarm > on the merdian.
Does zttool on the Asterisk box show anything interesting? The files in /proz/zaptel/* may provide some insight. Have you verified that _all_ your spans are set to E1? If the card is configured via the jumpers there could be a weak connection. Finally, are you sure the cable connecting the two is ok and properly crossed over? From your schematics above you will need a cross over cable when connecting span 4 on asterisk to the meridian. [snip] > The channel numbers do not seem right to me - although it works when I > have my working scenario !! The channel numbers seem correct to me. Peter _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
