Hi I've bought the Wildcard TE110 some days ago but I'm unable to get it to work with Siemens HiCom 300.
I've tried this so far: 1. I've used standard cat5 cable cut off on one edge and twisted wires 1 to 4 and 2 to 3 which is according to cisco a short circuit for E1 lines. Wildcard takes a few seconds and sets the link to green (OK). 2. I've tried to connect our running E1 line from the telco with wildcard. The modem (modulates HDSL to G703 120 Ohms). I've used a 1:1 cable that did not work. I even tried to connect the copper wires by hand which resulted that the modem gave me a green power light but Wildcard stayed on a waving red light. 3. I have plugged out our running PBX and connected it to Wildcard which resulted in a green light for one second and then the state from zttool switched to yellow (and Wildcard to constant red light). The protocol used by the modem is hdb3 and /etc/zaptel.conf is adjusted according to this. Can anyone clarify the different protocol layers and when fails what? When occurs the green light? Must protocol layer2 be established or even higher or is it just a layer1 link light. Please help me out. Jens _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users