I am trying to install [EMAIL PROTECTED] on a Dell 1650 server. The setup cd runs fine and completes with no errors but when I try to connect to the web site (http:myip/maint) to edit the configs nothing happens just a page not found error.
I'm not sure if there is a problem with my dual on board nics but when I check ifconfig I see the dhcp address info that was assigned for eth0 and then underneath some info about a loop back with the address 127.0.0.1. (I can ping the address assined from my other machie but I cannot see the address as leased in my dhcp server) I can successfully change the dhcp address to my own config for eth0 using netconfig but the loop back stuff remains when I use ifconfig to check the ip. Also I can't ever see the ip or config the ip on the second ethernet port. In addition the use of hostnae -i shows an ip of 127.0.0.1. If I use only the ethernet jack 1 and leave the second jack unplugged same result as above, but if I use only jack 2and leave jac 1 unplugged I see just the loopback info and nothing about eth0 with the defined ip and netconfig does nothing. Any help getting this up and runnign would be greatly appreciated. -Jonathan __________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection around http://mail.yahoo.com _______________________________________________ Asterisk-Users mailing list Asterisk-Users@lists.digium.com http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
