|
Mike
How many
modules on the TDM card?
When you
mention the FXS(green module) I assume only one.
if so then
fxoks=2-5 should be fxoks=2.
Regards
Dave
Hi,
Would someone assist me with the configuration of
my TMD10B and X100P cards? I would ask Digium but my support was good for only
one install...( I had to rebuild my * box). I wrote down the configuration but
I must have made a mistake somewhere. I have followed the instructions
on the Digium site but I must be missing something. Here's the config
(snippets) I've been attempting to use:
/etc/zaptel.conf
fxsks=1 # X100P
fxoks=2-5 the FXS(green) module is closest to the
bracket if you are looking at the side of the card with all of the electronic
components.
defaultzone=us
loadzone=us
/etc/asterisk/zapata.conf
echocancel=yes ; You can set this to 32, 64, or 128, tweak to your
needs.
echocancelwhenbridged=yes
echotraining=400 ; Asterisk trains to
the beginning of the call, number is in
milliseconds
callerid=asreceived
signalling=fxs_ks
group=1
context=incoming ; Points to the incoming context of your
extensions.conf
channel => 1
signalling=fxo_ks
callerid=
group=2
context=default
channel=> 2-5
When I run ztcfg -v I get an error message which says ZT_CHANCONFIG
failed on channel 2: invalid argument. Did you forget that FXS interfaces
are configured with FXO signalling and that FXO interfaces use FXS
signalling?
What am I doing wrong?
Thanks,
Mike
|
_______________________________________________
Asterisk-Users mailing list
[email protected]
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
