Shane Dalgleish wrote:
-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Eric Wieling
Sent: Friday, 18 February 2005 2:34 AM
To: Asterisk Users Mailing List - Non-Commercial Discussion
Subject: Re: [Asterisk-Users] Zap/g0/ to a Telstra Mobile
Howard Lowndes wrote:
On Thu, 2005-02-17 at 15:51, [EMAIL PROTECTED] wrote:
I've installed a TDM400. Having a go with AMP.
I would like incoming calls to be put throuhg to an
extension (at my
desk) and a mobile (cell phone) at the same time. Whichever
picks up,
gets the call..
This should be possible with AMP (call groups,
200|201|0*0408xxxxxx),
but it didn't work, so I have created a custom-incoming in extensions-custom.conf
What is happening is, The extension rings for about 5 secs
(as long as
it takes the TDM400 to dial the mobile number), then just
the telstra
mobile rings..
From asterisk -vvvvvvvvvvvr
-- Goto (custom-incoming,s,1)
-- Executing Dial("SIP/202-b424", "Zap/g0/0408xxxxxx&Sip/200|30|t") in new stack
-- Called g0/0408xxxxxx
-- Called 200
-- SIP/200-fece is ringing
-- SIP/200-fece is ringing
-- SIP/200-fece is ringing
-- SIP/200-fece is ringing
-- Zap/2-1 answered SIP/202-b424
This tend to indicate to me that the mobile system has
picked up the
call request on the zap channel and that * therefore thinks
that the
zap channel has picked up the call and will then bridge the zap channel to the sip 202 channel and kill off the ringing on
the sip 200 channel.
I don't know that there is much you can do about this as
basically you
are trying to get interaction on two different systems.
No. Analog ports are always considered "ANSWERED" as soon as Asterisk finishes dialing. This is covered over and over and over again in the mailing list archives. There are a few very ugly hacks to work around the problem.
Thanks Howard and Eric,
I did have a look around for this before I posted and I found a few references to: callprogress=yes (in zapata.conf)
But also read that this only (kinda) works in the US.
Also had a brief look at BackgroundDetect, but it looks a bit rough
What I do need to do urgently however is get rid of the 5 or so seconds of silence and static noise between the time Zap says the call is answered and Telstra establishes the call and starts ringing again..
So what I'm thinking is perhaps:-
- Call the phones in the office - Call the mobiles seperately but at the same time - wait for a DMTF tone from the mobile (I think I could put up with that) - bridges the call to the mobile - But if a Sip phone answers the call first hangup on the mobile - bridges the call to the Sip phone
Any thoughts on how I would go about that?
You can replace the "t" option with "tr" at the end of your Dial line. However, if the destination is busy then you may hear a couple of rings and then a busy sound.
Why are you using "t" in the first place?
You really do need a PRI or VoIP service provider. These things are not really issues with PRI or VoIP.
_______________________________________________ Asterisk-Users mailing list Asterisk-Users@lists.digium.com http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
