Dear list, I am trying to learn how to use Zap-things in Asterisk.
While loading Asterisk verbosely I get this error: [chan_zap.so]Warning, flexibel rate not heavily tested! => (Zapata Telephony w/PRI) == Parsing '/etc/asterisk/zapata.conf': Found Mar 12 17:19:01 WARNING[5563]: chan_zap.c:763 zt_open: Unable to open '/ dev/zap/channel': No such file or directory Mar 12 17:19:01 ERROR[5563]: chan_zap.c:6208 mkintf: Unable to open channel 1: No such file or directory here = 0, tmp->channel = 1, channel = 1 Mar 12 17:19:01 ERROR[5563]: chan_zap.c:9155 setup_zap: Unable to register channel '1-2' Mar 12 17:19:01 WARNING[5563]: loader.c:345 ast_load_resource: chan_zap.so: load_module failed, returning -1 == Unregistered channel type 'Tor' == Unregistered channel type 'Zap' Mar 12 17:19:01 WARNING[5563]: loader.c:440 load_modules: Loading module chan_zap.so failed! [EMAIL PROTECTED]:~> Ouch ... error while writing audio data: : Broken pipe Now, modprobing zaptel is ok: [EMAIL PROTECTED]:~> sudo /sbin/modprobe zaptel [EMAIL PROTECTED]:~> Same with wcfxo, wcfxs [EMAIL PROTECTED]:~> sudo /sbin/modprobe wcfxo [EMAIL PROTECTED]:~> sudo /sbin/modprobe wcfxs [EMAIL PROTECTED]:~> although here I do have a first question. The card I am using is a TDM400 with two FXS module, an empty slot and an FXO module. The wiki mentions a wctdm module that I do not find (modprobing it just fails). Am I missing something, or can I use the older set of kernel modules? [info: I did get the 1.0.6 zaptel, libpri and asterisk archives from the Digium site; I did compile everything under SUSE 9.2, thus with a stock 2.6.8-24-default kernel; I did use the make linux26 command in the install process of zaptel. ] Now the card seems to react to my fiddling: the three green leds corresponding to the installed module positions do turn on as soon as I type the wcfxo or wcfxs modprobe command. The zaptel config file is as follows: ************** zaptel.conf ************** the stock file as generated by the compile process, with the addition of these lines # edited by aaberga % 12.3.05 loadzone = us defaultzone = us fxsks = 1-2 #fxoks = 4 ************** zaptel.conf ************** The zapata.conf file is as follows: ************** zapata.conf ************** the stock file as generated by the compile process, with the addition of these lines ; edited by aaberga % 12.3.05 ;signalling = fxs_ks ;context = incoming ;channel => 4 signalling = fxo_ks context=internal channel => 1-2 ************** zapata.conf ************** I am obviously missing and/or misdoingsomething; can anybody help? Thanks in advance Aldo _______________________________________________ Asterisk-Users mailing list Asterisk-Users@lists.digium.com http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users