Am Dienstag 05 April 2005 18:04 schrieb Henry Jensen: > Hello, > > I've connected a TE110P from digium with a E1/T1 crossover cable, > according to http://www.voip-info.org/wiki-crossover+T1+cable, to > a s2m port on a Siemens Hipath 3750. > > The lights on the TE110p are flashing red and green, zttool reports > "Yellow Alarm" > > Asterisk says: > pri_dchannel: PRI got event: Alarm (4) on Primary D-channel of span 1 > pri_find_dchan: No D-channels available! Using Primary on channel anyway > 16 chan_zap.c:5647 handle_init_event: Detected alarm on channel 1: Yellow > Alarm chan_zap.c:5647 handle_init_event: Detected alarm on channel 2: > Yellow Alarm [...] > oh this sounds so familiar to me. got a Siemens hicom 300e here and had the same problem. I had a DB15 connector and when I got mad that it wasn't working like it was specified I cracked the connector open and found a weird non standard wiring from rj45 to db15. I twisted the wires like they were supposed to but then this blinking problem of yours occured to me and it vanished when I told Hicom to be the master of the line and * the slave. As from that point I got some minor errors in d-channel protocol which seem not to interfere with operational service although the d-channel went done for once for no obvious reason.
Jens _______________________________________________ Asterisk-Users mailing list Asterisk-Users@lists.digium.com http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users