Oh.. the voltage values are dumped in syslog!
Leandro Morgado wrote:
Damian Minkov wrote:
Is there a way to measure the signal of the connected line on the FXO
port ( without the help of digital oscilloscope )
Yes there is. But you need to edit the source code of wcfxs (for the
TDM400 card). There is a bit of code similar to:
#if 0
-->some debug messages here regarding voltage values
#endif
You can simply replace it for
a) if 1
This will always print out voltage values... LOTS of them!
or
b) if (debug>1) {....}
This will print out voltage values when you "modprobe wcfxs.c debug=2"
There should be similar bits of code in the X100P driver.
Leandro
_______________________________________________
Asterisk-Users mailing list
Asterisk-Users@lists.digium.com
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
_______________________________________________
Asterisk-Users mailing list
Asterisk-Users@lists.digium.com
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users