David: Bandwidth may be an issue; however, do you have any timing devices installed? Digium's hardware (or any generic knockoffs) will provide this. There are also some other ways, such as ztdummy or a usb controller (haven't used either of these, so I don't know any specifics. Check the Wiki).
-Andy On 5/3/05, [EMAIL PROTECTED] <[EMAIL PROTECTED]> wrote: > Hello, > > I have setup two * servers and they are communicating using IAX. I'm > passing calls from SRV A (internet connection T1) to SRV B (internet > connection: 512). > > For some reasons I have an issue with the quality. The voice is a bit > scratchy. I have tried iLBC and SPEEX, but it didn't make any difference. > > Now, assuming that I have an issue with Bandwidth, what would be the best > way to configure my iax.conf. (A bit confused about jitterbuffer and tos) > > Here is my iax.conf @ location A: > > [general] > port=4569 > bandwidth=low > disallow=all > allow=ilbc > ;allow=ulaw > ;allow=speex > jitterbuffer=200 > jitterbuffer=yes > tos=lowdelay > > and iax.conf @ location B: > > [general] > port=4569 > bandwidth=low > disallow=all > allow=ilbc > ;allow=ulaw > ;allow=speex > jitterbuffer=200 > jitterbuffer=yes > tos=lowdelay > > [guest] > type=user > context=default > callerid="Guest IAX User" > disallow=all > allow=ilbc > > Thanks guys > > _______________________________________________ > Asterisk-Users mailing list > Asterisk-Users@lists.digium.com > http://lists.digium.com/mailman/listinfo/asterisk-users > To UNSUBSCRIBE or update options visit: > http://lists.digium.com/mailman/listinfo/asterisk-users > _______________________________________________ Asterisk-Users mailing list Asterisk-Users@lists.digium.com http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users