-----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Alejandro G Sent: Thursday, 9 June 2005 1:52 PM To: asterisk-users@lists.digium.com Subject: [Asterisk-Users] Clicks in audio with TE100P PRI
Thanks for your answer. Googling in the lists I found what you are telling that maybe there is a synchro problem with the E1, but I'm not so sure that this could be. I am configuring zaptel.conf like this: span=1,0,0,ccs,hdb3 bchan=1-15,17-31 dchan=16 But I also changed to test to: span=1,1,0,ccs,hdb3 The same thing happens. You may consider also that if I connect PAP2 to LAN everything works, also if I use other ip phone from internet works fine. I also check if I'm loosing interrupts and everything seems ok. Also I pull out the TDM400 from the box. At last I change jitterbuffer=16 and it works better, the clicks are reduced. Could this be possible? What is the function of this parameter in zapata.conf? I should tell you that the TE100P is connected to another E1 board (not a live E1) from Natural Microsystems which acts as a gateway to PSTN. This board works as a PRI master but I don't think that this could be the problem as long as using other phones or in LAN it works perfectly and the voice is clear with no clicks o sound looses. Thanks again, Alejandro _______________________________________________ Asterisk-Users mailing list Asterisk-Users@lists.digium.com http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users _______________________________________________ Asterisk-Users mailing list Asterisk-Users@lists.digium.com http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users