Some correction to what I noted, if I make any change in FreePBX (like
just re-save an extension and apply changes), the truck starts answering
things properly. So it isn't just when I re-save the inbound route.
I will capture it going up and down and forward the log later tonight.
Regards,
Chuck
From: Claudius Fortis [mailto:[EMAIL PROTECTED]
Sent: September-07-07 2:21 PM
To: Chuck Mariotti; [email protected]
Subject: RE: [on-asterisk] SIP Trunk problem... IVR, Inbound Route or
Trunk issue?
Can you forward your logs....that sounds like something's skipping on
your dial plan...or the AA context is just no being executed at all...
________________________________
> Date: Fri, 7 Sep 2007 10:53:25 -0400
> From: [EMAIL PROTECTED]
> To: [email protected]
> Subject: [on-asterisk] SIP Trunk problem... IVR, Inbound Route or
Trunk issue?
>
> I have a new installation of Trixbox...
>
> After a period of time, when I call my single inbound VoIP Trunk, it
> just clicks and fast busy signals. It is supposed to go to the
Automated
> Attendant. If I go into FreePBX and just re-save/apply the same
Inbound
> Route in FreePBX, it seems to start working fine again. Then after a
> while, it stops working. I can make outbound calls without an issue,
it
> still just clicks for inbound.
>
> Has anyone run into this... it seems intermittent and I have no as to
if
> it is IVR, Inbound Route or a Trunk issue... or where to start to
debug
> it.
>
> Any suggestions?
>
> Regards,
>
>
> Chuck
>
>
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: [EMAIL PROTECTED]
> For additional commands, e-mail: [EMAIL PROTECTED]
>
________________________________
Explore the seven wonders of the world Learn more!
<http://search.msn.com/results.aspx?q=7+wonders+world&mkt=en-US&form=QBR
E>
