Ok so I was scouring the internet trying to figure out why my ntpd server
was not working.. in fact it was not running at all..
When I manually run it '/usr/sbin/ntpd -4 -c /etc/ntpd.conf' it runs
great
So I looked into the S30 script and found out the reason why it wont work.
I have no EXTIF defined or running (and I don't want one).
At some point I may want an EXTIF but right now im wanting to run local and
gain internet access through the customer's LAN.
In my rc.elocal I had to add the line 'route add default gw
xxx.xxx.xxx.xxx' to get a gateway to the internet.
I was hoping there would be a config option for that.
I could also put a line in there to start up my ntpd. But im looking to try
and do things the right way and not so much a hack..
(mainly so it isn't so tough when someone needs to change an IP or gateway
its all done in the same config or perhaps lonnie's gui).
The obvious answer I will hear is to run an EXTIF and no INTIF.. but I need
a DHCP server running.. and also the time server listening on the
interface..
What is the correct way for me to do what im looking to do?
Currently I have EXTIF="" and INTIF="eth1" and this works for the phone
system side no issues. just other things it wants to break.
-Christopher
------------------------------------------------------------------------------
This SF.net email is sponsored by Sprint
What will you do first with EVO, the first 4G phone?
Visit sprint.com/first -- http://p.sf.net/sfu/sprint-com-first
_______________________________________________
Astlinux-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/astlinux-users
Donations to support AstLinux are graciously accepted via PayPal to
[email protected].
