gree...@candelatech.com writes: > From: Ben Greear <gree...@candelatech.com> > > When testing a 10.4.3 firmware in station mode, I notice that > when the AP is powered down, the ath10k does not notice AP is gone > because mgt frames get tx status of 3, which is not handled. > > It appears that status 3 means something similar to failed-retry. > > Treating it thus lets the station disconnect properly. > > Tested against a non-stock 10.4.3 firmware, but likely upstream > firmware acts similarly in this case. > > Signed-off-by: Ben Greear <gree...@candelatech.com> > --- > > This patch is against a heavily patched tree based on 4.4, hopefully > it can be applied to upstream code w/out too much trouble. > > Someone should verify this on stock 10.4-ish firmware before applying.
Has anyone tested this with stock driver and stock firmware? Full patch here: https://patchwork.kernel.org/patch/8460831/ -- Kalle Valo _______________________________________________ ath10k mailing list ath10k@lists.infradead.org http://lists.infradead.org/mailman/listinfo/ath10k