On 24 August 2016 at 19:20, Ben Greear <gree...@candelatech.com> wrote: > On 07/19/2016 03:34 AM, Michal Kazior wrote: >> >> HW Rx filters and masks are not configured >> properly by firmware during boot sequences. The >> MAC_PCU_ADDR1 is set to 0s instead of 1s which >> allows the HW to ACK any frame that passes through >> MAC_PCU_RX_FILTER. The MAC_PCU_RX_FILTER itself >> is misconfigured on boot as well. >> >> The combination of these bugs ended up with the >> following manifestations: >> - "no channel configured; ignoring frame(s)!" >> warnings in the driver >> - spurious ACKs (transmission) on the air during >> firmware bootup sequences >> >> The former was a long standing and known bug >> originally though mostly harmless. >> >> However Marek recently discovered that this >> problem also involves ACKing *all* frames the HW >> receives (including beacons ;). Such frames >> are delivered to host and generate the former >> warning as well. >> >> This could be a problem with regulatory compliance >> in some rare cases (e.g. Taiwan which forbids >> transmissions on channel 36 which is the default >> bootup channel on 5Ghz band cards). The good news >> is that it'd require someone else to violate >> regulatory first to coerce our device to generate >> and transmit an ACK. >> >> The problem could be reproduced in a rather busy >> environment that has a lot of APs. The likelihood >> could be increased by injecting an msleep() of >> 5000 or longer immediately after >> ath10k_htt_setup() in ath10k_core_start(). >> >> The reason why the former warnings were only >> showing up seldom is because the device was either >> quickly reset again (i.e. during firmware probing) >> or wmi vdev was created (which fixes hw and fw >> states). >> >> It is technically possible for host driver to >> override adequate hw registers however this can't >> work reliably because the bug root cause lies in >> incorrect firmware state on boot (internal >> structure used to program MAC_PCU_ADDR1 is not >> properly initialized) and only vdev create/delete >> events can fix it. This is why the patch takes >> dummy vdev approach. >> >> This could be fixed in firmware as well but having >> this fixed in driver is more robust, most notably >> when thinking of users of older firmware such as >> 999.999.0.636. >> >> Reported-by: Marek Puzyniak <marek.puzyn...@tieto.com> >> Signed-off-by: Michal Kazior <michal.kaz...@tieto.com> > > > I was looking at firmware to make sure that I fixed what I could there.... > > From what I can tell, 10.4 should not have this bug. Did you see this only > on 10.1/10.2 firmware? It is of course possible that I am mis-understanding > 10.4....
I did see it on 10.1 and 10.2. Don't recall seeing it on 10.4 though. If you didn't see warnings on 10.4 even after adding msleep() as per commit log then I guess it doesn't suffer from the bug. MichaĆ _______________________________________________ ath10k mailing list ath10k@lists.infradead.org http://lists.infradead.org/mailman/listinfo/ath10k