Hi. We are trying to change transmission bandwidth and data rate. 1. We found that we can only control per-station channel width, and rate control, like Minstrel, is not controlled by ath10k and in firmware. Then, can ath10k select the transmission data rate manually? If so, how? We cannot find the part the data rate is determined.
2. Is it possible to change operating bandwidth per station while maintaining association? 3. We also want to use parameters related to channel sensing. Although we found that CCA related parameters are in firmware, we alternatively want to use parameters related to Ethtool in survey_info structure (in include/net/cfg80211.h, the structure below). However, when we read this variable in the log after Ethtrool running, the value does not seem to reflect channel sensing. Where and how can we use channel sensing parameters in ath10k? Is it possible? struct survey_info { struct ieee80211_channel *channel; u64 time; u64 time_busy; u64 time_ext_busy; u64 time_rx; u64 time_tx; u64 time_scan; u32 filled; s8 noise; }; Thank you. Sincerely yours, Changmok Yang. _______________________________________________ ath10k mailing list ath10k@lists.infradead.org http://lists.infradead.org/mailman/listinfo/ath10k