On 09/02/2016 02:11 PM, Alexis Green wrote:
Hello,
As I was working with ath10k drivers, I have discovered that only CT
firmware/driver combination is able to report tx_info to mac80211
layer. I've built latest LEDE image for my hardware (Netgear Nighthawk
X4S R7800) with both ath10k-ct driver from Ben and CT firmware. This
combination of software provides the data I need, however, the
throughput is severely limited :/
All tests are performed between two of these devices in mesh mode with
no encryption. Here are some of the iperf results:
I have not actually tested mesh-mode on my firmware, so maybe I caused
regressions related to that.
If you use AP + STA config, is throughput better?
What about IBSS?
What tx/rx rates is CT firmware actually reporting? Maybe it is not
enabling HT/VHT for some reason?
Thanks,
Ben
--
Ben Greear <[email protected]>
Candela Technologies Inc http://www.candelatech.com
_______________________________________________
ath10k mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/ath10k
