Erik Stromdahl <[email protected]> writes:
> Hardware parameters for QCA9377 usb devices.
>
> Signed-off-by: Erik Stromdahl <[email protected]>
[...]
> --- a/drivers/net/wireless/ath/ath10k/core.c
> +++ b/drivers/net/wireless/ath/ath10k/core.c
> @@ -328,6 +328,29 @@ static const struct ath10k_hw_params
> ath10k_hw_params_list[] = {
> .vht160_mcs_rx_highest = 0,
> .vht160_mcs_tx_highest = 0,
> },
> + {
> + .id = QCA9377_HW_1_1_DEV_VERSION,
> + .dev_id = QCA9377_1_0_DEVICE_ID,
> + .name = "qca9377 hw1.1 usb",
> + .patch_load_addr = QCA9377_HW_1_0_PATCH_LOAD_ADDR,
> + .uart_pin = 6,
> + .otp_exe_param = 0,
> + .channel_counters_freq_hz = 88000,
> + .max_probe_resp_desc_thres = 0,
> + .cal_data_len = 8124,
> + .fw = {
> + .dir = QCA9377_HW_1_0_FW_DIR,
> + .board = QCA9377_HW_1_0_BOARD_DATA_FILE_USB,
> + .board_size = QCA9377_BOARD_DATA_SZ,
> + .board_ext_size = QCA9377_BOARD_EXT_DATA_SZ,
> + },
> + .hw_ops = &qca988x_ops,
> + .decap_align_bytes = 4,
> + .max_num_peers = TARGET_QCA9377_HL_NUM_PEERS,
> + .is_high_latency = true,
> + .bus = ATH10K_BUS_USB,
> + .start_once = true,
> + },
Oh, forgot to mention that adding hw_params entry should be last in the
patchset and only added once all fixes etc are already in place (eg
patch 10 and 11 should be before this).
--
Kalle Valo
_______________________________________________
ath10k mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/ath10k
