2010/12/6 Jonathan Guerin <jonat...@guerin.id.au>: > Hi, > > > I've been doing some investigation into the behaviour of contention > windows and retransmissions. > > Firstly, I'll just describe the test scenario and setup that I have. I > have 3 Via x86 nodes with Atheros AR5001X+ cards. They are tethered to > each other via coaxial cables, into splitters. They have 20dB of fixed > attenuation applied to each antenna output, plus a programmable > variable attenuator on each link. One node acts as a sender, one as a > receiver, and one simply runs a monitor-mode interface to capture > packet traces. All 3 are running kernel version 2.6.37-rc2. The sender > and receiver are configured as IBSS stations and are tuned to 5.18 > GHz. > > Here's a really dodgy ASCII diagram of the setup: > > S-----[variable attenuator]-----R > | | > | | > | | > +------------M-------------------------+ > > where S is the Sender node, R is the Receiver node and M is the > Monitoring capture node. > > > Secondly, I have written a program which will parse a captured pcap > file from the Monitoring station. It looks for 'chains' of frames with > the same sequence number, and where the first frame has the Retry bit > set to false in the header and all following have it set to true. Any > deviation from this, and the program drops the current chain without > including it in its stats, and looks for the next chain matching these > requirements. It averages the amount of time per transmission number > (i.e. the average of all transmissions which were the first, second, > third etc. for a unique sequence number). The transmission time of a > frame is the amount of time between the end of the frame and the end > of the previous. It tracks these 'chains' of frames with the same > sequence number. It considers the last transmission number in each > chain as the 'final' transmission. > > Finally, the link is loaded using a saturated UDP flow, and the data > rate is fixed to 54M and 36M. This is specified in the output. The > output is attached below. > > The output describes the fixed link data rate, the variable > attenuator's value, the delivery ratio, and the number of transmitted > packets/s. I've added a discussion per result set. Each line outputs > the transmission number, the average transmission time for this > number, the total number of transmissions, the number of frames which > ended their transmissions at this number (i.e. where the chain ended > its final transmission - this is equivalent to the retransmission > value from the Radiotap header + 1), and the average expected > transmission time for all that particular transmission number in all > chains. This is calculated using the airtime calculations from the > 802.11a standard, with the receipt of an ACK frame, as well as a SIFS > (16us), which is 28us. If the transmission did not receive an ACK, a > normal ACK timeout is 50 us, but ath5k appears to have this set to 25 > us, so the value shouldn't be too far out what to expect. >
Did you measure ACK timeout or 25 is what you get from the code ? Because from what we know so far hw starts counting after switching to RX mode so phy rx delay (25 from standard) is also added. -- GPG ID: 0xD21DB2DB As you read this post global entropy rises. Have Fun ;-) Nick _______________________________________________ ath5k-devel mailing list ath5k-devel@lists.ath5k.org https://lists.ath5k.org/mailman/listinfo/ath5k-devel
