On 03/07/2012 05:00 PM, Adrian Chadd wrote: > On 7 March 2012 13:17, Ben Greear<gree...@candelatech.com> wrote: >> I put two ath9k (AR9300) nics in one machine, with >> 6 antenna poking out, and had one NIC be the AP >> for the other. > > How far apart are there?
Well, here's a picture: http://www.candelatech.com/images/systems/lf0310-back-lo-72dpi.jpg 3 antenna on that pci faceplate are to NIC A, and the right antenna and ones connected to the case are to NIC B. >> It works, but I'm seeing lots of CRC errors and station-to-station throughput >> is only about 5Mbps (one sending to the other). > > >> I tried setting xmit power lower (to 4, for instance), but that >> doesn't change the behaviour much. > > Well, that's still going to be quite powerful. Can you try setting it to 1 or > 2? Sure, will do that tomorrow. > I wonder what RX attenuation setting(s) are being used. An RSSI of ~22 > is quite strong. It doesn't -seem- strong enough to cause big issues > though. How do I figure this out? > Hm, what about setting tx/rx chainmask to 1 on both sides? I'm not sure how to do this either..will poke around tomorrow. Thanks, Ben -- Ben Greear <gree...@candelatech.com> Candela Technologies Inc http://www.candelatech.com _______________________________________________ ath9k-devel mailing list ath9k-devel@lists.ath9k.org https://lists.ath9k.org/mailman/listinfo/ath9k-devel
