What kind of commands did you try to send? I will try the same with my dongle and update you if that works or not;)
2013/5/2 Oleksij Rempel <li...@rempel-privat.de>: > Am 02.05.2013 09:15, schrieb Eugene Krasnikov: > >> Hi Oleksij, >> >> Have you tried remote debugging? Or it's only about garbing logs from >> the chip. Have you tried to send commands to the chip? > > > Yes, it works. You need this resistors to make chip start with ttl adapter > attached. Without them this chip may not start. > > >> 2013/5/2 Oleksij Rempel <li...@rempel-privat.de>: >>> >>> Am 28.04.2013 16:17, schrieb Oleksij Rempel: >>>> >>>> >>>> Am 28.04.2013 13:38, schrieb Adrian Chadd: >>>>> >>>>> >>>>> .. is it triggering BREAK interrupts or something? >>>> >>>> >>>> >>>> I don't know, there is no serial output on this stage. JTAG may help if >>>> the protocol is some how similar to EJTAG. Are there any documentation >>>> about Xtensa dubug interface ;)? >>>> I will need to dig in it, but not this week. >>>> >>>> >>>>> That may be something that the boot ROM code interprets as a magical >>>>> "don't start" sequence or something. >>> >>> >>> >>> So, this issue is fixed now. >>> >>> ttl TX >------[2K]--------o RX pin on AR7010 >>> |----[4K pull up]---< 3,3V >>> >>> In attachment are pictures from my setup ;) >>> >>> -- >>> Regards, >>> Oleksij >> >> >> >> > > > -- > Regards, > Oleksij -- Best regards, Eugene _______________________________________________ ath9k-devel mailing list ath9k-devel@lists.ath9k.org https://lists.ath9k.org/mailman/listinfo/ath9k-devel