On Thu, May 16, 2013 at 03:27:15PM +0200, thus spake Oleksij Rempel: > Am 15.05.2013 15:42, schrieb Ignacy Gawedzki: > >Hi everyone, > > > >This is an old issue, about which it seems the first posts date back to 2009. > >With the latest possible version of the firmware for AR9271 and the latest > >possible wireless drivers, the issue is still there. Whether this is still > >the exact same problem every time remains to be checked, but it is annoying > >enough to deserve some consideration. > > > >The problem is that the driver can't talk to the device if the following > >conditions are met: > > > > - The system cold boots with the USB dongle inserted or the USB dongle is > > inserted on a running system. > > > > - The interface is *not* brought up. > > > > - The system (warm) reboots. > > > >Then the driver complains about the target being unresponsive after uploading > >the firmware. Apparently the only way to make it work again is to unplug and > >then plug the USB dongle back, physically. It seems that if the USB port is > >not powered down during reboot (which happens with at least two different > >setups that I've tested it with), the device is left in a broken state. > > > >I would gladly help in tracing down this bug if only I knew where to start. > > > >Thanks for any suggestion. > > Hi Ignacy, > > i can't reproduce this issue on my system. I tested it with 4 > different ath9_htc adapter. Without luck.
Without luck, but it seems you're the lucky one anyway. =) > Please provide as match > information as possible: > - Usb host controller Tested both on Raspberry Pi and on Dell XPS 13. The latter uses Intel EHCI, 8086:1c2d and Fresco Logic 1b73:1009, I don't know which one is used exactly. > - Adapter manufacture and version, or even better add it to the > wiki, and upload some images: > http://wikidevi.com/wiki/Main_Page TP-Link TL-WN722NC, exactly as the one on the wiki. > - your kernel version Tested with 3.5.0 on XPS and 3.6.11, 3.8.12 and 3.9.2 on RPi (using a customized buildroot, but I can provide the .config if needed). > I assume it is not firmware. May be there are some issue with boot > loader on adapter. Are you sure that UART pins are not soldered? I opened the dongle, managed to solder the metal shield off and the pins weren't used (all four 48-51, among others). > Current ath9k_htc do not have mechanism to reset an adapter. I will > start to work on it after some other issues are done. Is it physically possible? > PS: please find some way to enable uart, at least TX pin. I tried to solder the TX pin, but it's really too tiny. I don't have an iron so small as to be able to do it, sorry. I would really love to have an UART connection, but that's just beyond my abilities. BTW, it would really be great to have a way to send debug message up the USB link, just as with carl9170. Thanks for your help anyway, I hope we'll find a way to make that work. -- Sex on TV doesn't hurt....unless you fall off. _______________________________________________ ath9k-devel mailing list ath9k-devel@lists.ath9k.org https://lists.ath9k.org/mailman/listinfo/ath9k-devel