Hey Philip, David, We've had a couple of reports but nothing wide-spread. I've given a couple of Microsoft people a nudge and they are also making sure the right people are having a look.
Gavin On Thu, 4 Jun 2020 at 10:29, David Allen <da...@virtutel.com.au> wrote: > Hi Philip, > > Can confirmed we have experienced the same issue and I have a ticket > lodged with both Megaport and Microsoft over it. It seems to be fine over > Equinix IX however. > > Regards > David > > > > Kind regards, > > *David Allen | Director, CTO* > P: 1300 655 132 or +61 3 9999 8800 F: +61 3 9999 8899 > E: da...@virtutel.com.au W: www.virtutel.com.au > A: Level 9, 401 Collins Street, Melbourne, Victoria, 3000, Australia > > > > > > This e-mail message and any accompanying attachments may contain > confidential information. If you are not the intended recipient, do not > read, use, disseminate, distribute or copy this message or attachments. If > you have received this message in error, please notify the sender > immediately and delete this message. Any views expressed in this message > are those of the individual sender, except where the sender expressly, and > with authority, states them to be the views of Virtutel Before opening any > attachments, please check them for viruses and defects. > > On 4 Jun 2020, at 12:13 pm, Philip Loenneker < > philip.loenne...@tasmanet.com.au> wrote: > > Good morning everyone, > > We became aware of issues this morning for clients on our network reaching > some Azure workloads and Office365 services. Traffic was reaching the > remote end of our bilateral peer with Microsoft over Megaport Melbourne, > but we had connectivity issues reaching hops past that. We stopped sending > and receiving routes via this peer (keeping the BGP peer up for testing > purposes) and after a few minutes most services appeared to be back to > normal, with the traffic currently preferring a path via NSW-IX. > > Since then however, we’re still having issues with Azure workloads in > AU-SE region. We’re seeing 42% error rate in initiating connections to some > VMs. > > I’ve logged a fault directly with Microsoft, and they are investigating, > but I was wondering if anyone else is having similar issues that could help > to isolate the cause. I can share the incident number with others > experiencing problems if it is helpful. > > Regards, > *Philip Loenneker | Senior Network Engineer** | TasmaNet* > 40-50 Innovation Drive, Dowsing Point, Tas 7010, Australia > P: 1300 792 711 > philip.loenne...@tasmanet.com.au > www.tasmanet.com.au > > _______________________________________________ > AusNOG mailing list > AusNOG@lists.ausnog.net > http://lists.ausnog.net/mailman/listinfo/ausnog > > > _______________________________________________ > AusNOG mailing list > AusNOG@lists.ausnog.net > http://lists.ausnog.net/mailman/listinfo/ausnog > -- Global Interconnection Director Megaport <https://www.megaport.com> +61 424 229 127
_______________________________________________ AusNOG mailing list AusNOG@lists.ausnog.net http://lists.ausnog.net/mailman/listinfo/ausnog
