Hi, I am new to program Command Module for iRobot create. I started following instructions from "iRobot Command Module Owner's Manual" input example and able to successfully create input.hex
However when I start downloading project over the USB link, I get the timout message for unlimited period of time. The output that I get is avrdude -p atmega168 -P com9 -c stk500 -U flash:w:input.hex avrdude: stk500_2_ReceiveMessage(): timeout avrdude: stk500_2_ReceiveMessage(): timeout avrdude: stk500_2_ReceiveMessage(): timeout avrdude: stk500_2_ReceiveMessage(): timeout avrdude: stk500_2_ReceiveMessage(): timeout avrdude: stk500_2_ReceiveMessage(): timeout avrdude: stk500_2_ReceiveMessage(): timeout avrdude: stk500_2_ReceiveMessage(): timeout avrdude: stk500_2_ReceiveMessage(): timeout avrdude: stk500_2_ReceiveMessage(): timeout avrdude: stk500_2_ReceiveMessage(): timeout avrdude: stk500_2_ReceiveMessage(): timeout avrdude: stk500_2_ReceiveMessage(): timeout avrdude: stk500_2_ReceiveMessage(): timeout ................................................................... ................................................................... ................................................................... I ensured to use COM9 in makefile as well as for "USB Serial Port (COM9)". I also have tried to reset command module before [WinAVR] Program but there is no use. I am sure, I am doing some mistake making my iRobot create command module not to properly communicate and expect an expert identifying the issue. Thanks a lot, -- Ahmad
_______________________________________________ AVR-chat mailing list [email protected] http://lists.nongnu.org/mailman/listinfo/avr-chat
