I built a board around an XMEGA and I'm able to use PDI to program it both from
OS X/avrdude and AVR Studio 6 using an AVR ISP Mk II.
But trying the same thing with Dragon, it doesn't work. When I try to read the
device ID, I get an alert saying:
"Unable to enter programming mode. Please verify device selection,
interface settings, target power and connections to the target device."
I was able to use this Dragon via JTAG to the Xplain board, but I don't have a
JTAG connector on my board. I've also disabled JTAG via fuses, is it required
to be enabled to allow PDI debugging? I hope not!
Any ideas?
--
Rick
_______________________________________________
AVR-chat mailing list
[email protected]
https://lists.nongnu.org/mailman/listinfo/avr-chat
