Hi, Im, of cause, not fully following yr system; but what do y want to achive with .. [1] in yr write statements ? /g ----Ursprungligt meddelande---- Från : [email protected] Datum : 2018-01-28 - 01:11 (V) Till : [email protected] Ämne : [avr-chat] EEMPROM Error with ATtiny1634 Hi, I' trying to write an .eep, and get always: "verification error, first mismatch at byte 0x0000" I was hunting the problem down to with this small code sequence (_writeNumber outputs a byte via the UART): uint8_t test[5] EEMEM = { 3, 4, 5, 6, 7}; uint8_t test2[128] EEMEM = { 9, 8, 9, 9, 9}; (...) _writeNumber (eeprom_read_byte(&test[1])); _writeNumber ((uint8_t)(int)&test[1]); _writeNumber (eeprom_read_byte(&test2[1])); _writeNumber ((uint8_t)(int)&test2[1]); eeprom_write_byte (&test[1], 25); eeprom_write_byte (&test2[1], 26); _writeNumber (eeprom_read_byte(&test[1])); _writeNumber ((uint8_t)(int)&test[1]); _writeNumber (eeprom_read_byte(&test2[1])); _writeNumber ((uint8_t)(int)&test2[1]); I get the following output: 000129 >> test value 2 in EEPROM address 129: is 0, should be 4 004001 >> test2 value 2 in EEPROM address 1: is 4, should be 8 025129 >> just to proove the EEPROM is not currupt - writing address 129 from code works 026001 >> just to proove the EEPROM is not currupt - writing address 1 from code works It seems like the bytes starting with address 128 get actually written from address 0. Testing the same code with a ATmega1284 works like a charm, hence I assume the .eep file is correct (created with avr-gcc). I was investigating already a bit in the avrdude.conf, but cannot verify if the problem comes from there or from elsewhere. Attached the eep file, and the relevant conf section. Many thanks for any hint... best regards, muli
_______________________________________________ AVR-chat mailing list [email protected] https://lists.nongnu.org/mailman/listinfo/avr-chat
