Hi, maybe dirty solution, but if you have some generator (or if you build one with 2x operational amplifier), you can push few hundreds khz to XTAL1 pin. Basically is is simple solution for SMD designs. At least this worked with ATmega32 and 16. Then you should be able to re-program fuses again.
Best regards Martin On Sun, Mar 25, 2018, 22:18 Thomas D. Dean <[email protected]> wrote: > On 03/25/18 12:05, Kimson Muriungi wrote: > > Hi guys, > > > > I have a custom mega 2560 avr control board that I just got bricked by > > setting the wrong fuses accidentally. It is surface mount, so i cannot > > use fuse bit doctor or high voltage programming to reset it. Sadly I > > also didnt include JTAG in my design. The fuses have been set to Low > > frequency crystal oscillator. The only thing I have around that could > > help is a USBTiny ISP programmer, and a 32khz crystal, which i hoped > > would probably provide the low frequency to make it run as per the fuse > > settings. I have not managed to change that until now. I am aware that > > ISP programming frequency should be utmost 1/4 of the 32 khz. Is there a > > way I can set ISP frequency of that level (6 to 8 khz) using avrdude and > > command prompt? Probably I'll be able to reset the fuses this way. > > > > Or if there is any other way Id bring this chip back, I'd gladly use it. > > > > https://learn.adafruit.com/usbtinyisp/avrdude > > Tom Dean > > _______________________________________________ > AVR-chat mailing list > [email protected] > https://lists.nongnu.org/mailman/listinfo/avr-chat >
_______________________________________________ AVR-chat mailing list [email protected] https://lists.nongnu.org/mailman/listinfo/avr-chat
