> ---------------------------------------------------------------------
> 
> Message: 1
> Date: Sun, 28 Jan 2007 20:54:14 +0100
> From: Pierre GAUFILLET <[EMAIL PROTECTED]>
> Subject: Re: [Aximx50-port] Touchscreen chip is not an ADS 7846
> To: The porting effort for the Dell Axim x50
>       <[email protected]>
> Message-ID: <[EMAIL PROTECTED]>
> Content-Type: text/plain; charset=UTF-8
> 
> Hi,
> 
> the touchscreen is now working (probably for X50 and for sure for X51).
> I will post a first patch soon.
> I still have to define the coordinates transformation.
> 
> Paul : I see you committed a new 7846 device-independent driver. Should
> I use this one from now ?
> 
> Could you please commit the following modification to
> include/asm-arm/arch-pxa/memory.h ?
> 
> #ifdef CONFIG_DRAM_BASE
> #define PHYS_OFFSET     (CONFIG_DRAM_BASE)
> #else
> #define PHYS_OFFSET     UL(0xa0000000)
> #endif
> 
> For Axim X50/X51(v), the current kernel can not be used without a manual
> modification...

Nice job Pierre,

On my side, i am still trying to get Bluetooth working.
Brf6150 device is for sure plugged on pxa BT UART (that is to say ttyS1)
 
I am still figuring out what should be done in order to power ON and
reset the device ...
 
On hx4700 (which has also a brf6150), power ON is done by setting bit 5
of egpio register to 1, and reset of the device is done using GPIO 106.
Bad luck, this does NOT work on axim ....

So i am playing with Haret to look at GPIO's behavior when
enabling/disabling Bluetooth... GPIO 22 seems to be consistently set to
1 each time bluetooth is ON (and reset to 0 if turned OFF)

Another matter : i am NOT sure that EGPIO is located at PXA Chip selects
5 / offset 0 .....

Once brf6150 is reset and in idle, just "modprobe hci_uart" and
"hciattach /dev/ttyS1 texas 115200" should do the rest ....

Any help is welcome !
Nicolas.


 






-- 
_______________________________________________
Aximx50-port mailing list
[email protected]
https://www.handhelds.org/mailman/listinfo/aximx50-port

Reply via email to