Dear B.A.T.M.A.N List,
i've installed BATMAN v0.3.2 in a ethernet network to dynamicly route my
network-informations. Before switching to BATMAN, i've used OLSR.
With OLSR all things went fine. But since my network grows faster as
intended, i like to switch to BATMAN.
NOW TO MY PROBLEM:
I like to announce a gateway that is behind an VPN-Tunnel. The
VPN-Tunnel is established, before BATMAN is running.
When i try to start BATMAN on the Gateway with this options:
batmand -g 30mbit/2mbit
the clients will create a gate0 interface. I do not need this gate0
interface. All routers have static public ip-addresses assigned. The
once that i need is, that BATMAN inserts a DEFAULT-ROUTE to the next
neighbour hop thats reach the gateway.
NETWORK-Setup:
1. i386 Router located on ISP runs batman as gateway-provider
xxx.205.12.0/32 brd 255.255.255.255
<--- VPN-Tunnel over ISP-Network --->
xxx.205.12.4/32 brd 255.255.255.255
2. i386 Router located at home #1
xxx.205.12.17/30 brd xxx.205.12.19
<--- Wireless Bridge-Connection --->
xxx.205.12.18/30 brd xxx.205.12.19
3. i386 Router located at home #2
xxx.205.12.21/30 brd xxx.205.12.23
<--- Wireless Bridge-Connection --->
xxx.205.12.22/30 brd xxx.205.12.23
4. i386 Router located at home #3
How can i tell BATMAN (gateway) to announce 0.0.0.0/0 as HNA?
# batmand -c -a 0.0.0.0/0
Invalid announced network (netmask is invalid): 0.0.0.0/0
I dont like to setup a second VPN / P2P Tunnel, because thats not needed.
Thanks in advance,
Michael
