Hey Robert,
> > > - Could the short distance be a problem?
> >
> > well you have interference between the nodes and the typical
> > throughput limitations because of the half-duplex nature of WiFi. But
> > if you take that into consideration and don't expect the same
> > throughput as on a single link, 3-4 meter should be fine.
>
> Do you have any good literature/link recommendation where I could learn
> more about the low level WiFi mechanics?
>
Mhm, I'd generally recommend the Matthew Gast books on 802.11, these are very
good.
The throughput limitation I'm talking about is a mesh-network specific problem
when you use single radios only: as a wifi radio can only transmit or receive
at the same time, the throughput will be cut to 50% with the first hop, and
will decrease furhter with more hops. I don't know if there are books about
such effects, but there are certainly papers ...
> > It also depends on what kind of data you will send (many industrial
> > applications use broadcast, for example).
>
> Broadcast is not necessary, all traffic is generated somewhere on the
> line and sent out to the Gateway. The datasets are in the 500 KiB range,
> it could be UDP or TCP, not decided yet. But it's definitely unicast.
OK, then you can use high datarates too.
> > > - Is it possible to regulate the transmission power in order to avoid
> > >
> > > disturbance?
> >
> > There are WiFi driver which allow that, yes.
>
> Can you give me a hint which feature I need to search for in the kernel
> drivers?
ath9k supports that for example. you can set the txpower using "iw wlan0 set
txpower 1500" for example to set to 15dBm output pwoer
>
> As the stations will be built from scratch (SoC+RAM+Flash+Wifi-Chipset),
> we can chose the right chipsets, as long as it's possible to buy them
> somewhere.
>
I'd definitely recommend to buy WiFi modules (e.g. pci-e) or off-the-shelf
boards with WiFi SoCs on it. If you don't have experience in building WiFi
routers, you might have a lot of fun otherwise. :)
> > However I'd recommend to keep it as it is and change the broadcast
> > rate to something higher (e.g. 18M or more) to force to only use good
> > links, even if they are a little shorter.
>
> Ok. I'll setup a bunch of prototype devices in the first place anyway,
> so we can try it out then.
>
> Thanks for the infos!
Good luck!
Simon
