Hello everyone.
I have three mesh nodes. Node A don’t see node C. A can't communicate
with C directly, but it can commuticate with C via node B, which is
between A and C. The path is A - B - C.
On node A, I can run the command 'batctl ping MAC' to node B and node
C successfully.
When i try the normal layer 3 ping [ping IP] it’s ok to node B for
node C doesn't work.
Maybe i have a wrong configuration at layer 3.
My configurations:
/etc/config/network
config interface 'lan'
option ifname 'eth0.1'
option type 'bridge'
option proto 'static'
option ipaddr '192.168.0.1'
option netmask ‘255.255.255.0'
config interface 'mesh'
option ifname 'adhoc0'
option mtu '1528'
option proto 'static'
option mesh 'bat0'
option ipaddr '192.168.11.1'
option netmask ‘255.255.255.0'
/etc/config/wireless
config wifi-iface
option device 'radio0'
option ifname 'adhoc0'
option network 'mesh'
option mode 'adhoc'
option ssid 'batman-mesh'
option encryption 'none'
option bssid '02:CA:FE:CA:CA:40’
/etc/config/batman-adv
config mesh 'bat0'
option interfaces 'adhoc0'
option 'aggregated_ogms'
option ‘ap_isolation'
[..]
root@OpenWrt:~# batctl if
adhoc0: active
the difference between nodes is the ip address for interface
lan(192.168.0.1, 192.168.2.1, 192.168.3.1) and mesh (192.168.11.1,
192.168.11.2, 192.168.11.3)
What i need to setup to can ping from node A to C?
Best Regards.
