On 10/18/2011 12:23 PM, Jesús Vidal Panalés wrote:
El 18/10/11 17:34, Larry Finger escribió:
On 10/18/2011 10:05 AM, Jesús Vidal Panalés wrote:
Running Wireshark on this laptop and capturing wireless interface does not show
traffic at all. So there is something wrong.
For unknown reasons, wireshark fails to capture data on my computer as well
abd my BCM4303 works. Use kismet.
Larry
Ok. I've installed kismet, i've edited kismet.conf file, setting only source to
this: source=b43legacy,wlan0,addme
I ran kismet, and i can see my wifi essid. Packts is updating everytime, so
sniffing is working fine. Now, what can i do with kismet to probe if my card is
sending packets?
In general, do not drop the mailing list from the distribution list. ALWAYS use
"reply-all". All of my debugging is made available on the list. If you do not
accept that restriction, then I will be unable to help you.
You can analyze the .pcap file produced by kismet with wireshark. Look for probe
requests from your BCM4303 and the response from the AP. If you cannot analyze
the data, it is OK to send the pcap file to me privately. I will limit the
traffic to just your ESSID and post it on the list if I cannot figure out what
is wrong.
Larry
_______________________________________________
b43-dev mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/b43-dev
