On Thursday 06 November 2008 22:47:41 Ralf Gross wrote: > Alex Chekholko schrieb: > > On Wed, 5 Nov 2008 16:12:51 +0100 > > > > Kern Sibbald <[EMAIL PROTECTED]> wrote: > > > For writing to tape (providing it is LTO-n) I strongly recommend a > > > block size not to exceed 256K. > > > > Hi Kern, > > > > Why do you say that? Is this thread relevant?: > > http://www.mail-archive.com/[email protected]/msg01246.h > >tml > > > > Also, I would like to corroborate the OP's experiences; I had an almost > > identical thread about small block size and slow write speed: > > http://www.nabble.com/LTO-4-performance--td17407840.html > > > > In fact, I was unable to get higher block sizes working at all with > > btape: > > http://www.adsm.org/lists/html/Bacula-users/2008-05/msg00504.html > > > > So I am still stuck at ~22MB/s writing to LTO-4 with the default block > > size. > > I don't think that the blocksize is the problem. I did some tests but > couldn't get higher results with larger blocksizes. I get 75-85 MB/s > with the default bs and no additional tuning. >
That is probably correct, but most likely only because you have a bottleneck elsewhere -- probably in one of the points I mentioned. The speed is always capped by the slowest component. Once you remove the other bottlenecks on your system, the blocksize will very likely become the bottleneck and then you can measure the difference. ------------------------------------------------------------------------- This SF.Net email is sponsored by the Moblin Your Move Developer's challenge Build the coolest Linux based applications with Moblin SDK & win great prizes Grand prize is a trip for two to an Open Source event anywhere in the world http://moblin-contest.org/redirect.php?banner_id=100&url=/ _______________________________________________ Bacula-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/bacula-devel
