Hello,
On 15.10.2005 21:05, Kern Sibbald wrote:
I suspect that what is requested is already implemented. Just do an
llist volume=<some-volume>
to see all the fields available. If you want to see more fields a new query
could give you the information ...
I assume that answer is directed to Gregory more than me, right?
Because I miss the VolUseDuration actually filled...
... and data about the drive usage, too.
Arno
On Saturday 15 October 2005 20:29, Arno Lehmann wrote:
Hello,
On 15.10.2005 03:15, Gregory Brauer wrote:
It would be useful if the timestamp when a volume was labeled
was stored in the volume table and shown with a "list volumes".
This would be helpful for planning when to replace tapes in a
loader.
Yes, but it would even be better to record the actual writing and
reading time for each tape. he best thing is - theserecords already
exist in the catalog, but are not yet used (as far as I know). once 1.38
is released, Kern will probably ask for suggestions and volunteers for
baculas further development.
I will suggest something :-)
Arno
Thanks.
Greg Brauer
[EMAIL PROTECTED]
-------------------------------------------------------
This SF.Net email is sponsored by:
Power Architecture Resource Center: Free content, downloads, discussions,
and more. http://solutions.newsforge.com/ibmarch.tmpl
_______________________________________________
Bacula-users mailing list
Bacula-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/bacula-users
--
IT-Service Lehmann [EMAIL PROTECTED]
Arno Lehmann http://www.its-lehmann.de
-------------------------------------------------------
This SF.Net email is sponsored by:
Power Architecture Resource Center: Free content, downloads, discussions,
and more. http://solutions.newsforge.com/ibmarch.tmpl
_______________________________________________
Bacula-users mailing list
Bacula-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/bacula-users
