Hello Matjaz,
On Tuesday 15 November 2005 11:37, Matjaz Slibar wrote:
> Dear Kern,
> Dear Group
>
> I am using bacula 1.36.2-2 on Debian Sarge with HP StorageWorks DAT72
> internal tape drive. Everything is working fine, except when one backup
> job spans over two tapes. In this situation Bacula destroys second
> cartridge. The cartridge is not usable any more even with tar. When I
> insert destroyed cartridge in the cartridge door the tape LED is
> flashing and after a while it switches off. When I insert good cartridge
> the tape LED is flashing and after a while it stays on.
>
> I also tested my tape drive with btape with multiple tape option (It
> works fine with simple single tape option.) and bacula again destroyed
> cartridges (in this example both). I am attaching log file of this test
> (btape-err.txt).
>
> Can anybody help me? I was reading manual and searching the mailing
> lists without success.
I doubt very much that Bacula can destroy a tape. It uses only normal system
calls.
However, from the ouput listing you included, it *appears* that you are using
"Offline on Unmount = yes". This directive is most likely causing your tape
drive to "lock up" after the tape is ejected. It requres either a power off
or a "load" to get it going again. The exact behavior depends a lot on the
drive. If you remove this directive from your Device resource, you will
probably have more luck.
--
Best regards,
Kern
(">
/\
V_V
-------------------------------------------------------
This SF.Net email is sponsored by the JBoss Inc. Get Certified Today
Register for a JBoss Training Course. Free Certification Exam
for All Training Attendees Through End of 2005. For more info visit:
http://ads.osdn.com/?ad_id=7628&alloc_id=16845&op=click
_______________________________________________
Bacula-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/bacula-users
