On Fri, 15 Jun 2007 15:03:28 -0600
Ken Gunderson <[EMAIL PROTECTED]> wrote:
[snip]
>
> Relevant bacula-sd.conf config:
>
>
> Autochanger {
> Name = Autochanger
> Device = Drive-1
> Changer Command = "/usr/local/etc/bacula/mtx-changer %c %o %S %a %d"
> Changer Device = /dev/pass1
> }
>
> Device {
> Name = Drive-1 #
> Drive Index = 0
> Media Type = LTO-2
> Archive Device = /dev/nsa0
> AutomaticMount = yes; # when device opened, read it
> AlwaysOpen = yes;
> RemovableMedia = yes;
> RandomAccess = no;
> AutoChanger = yes
> Alert Command = "sh -c 'tapeinfo -f %c |grep TapeAlert|cat'"
> # btape test results advise tweaking thusly...
> Hardware End of Medium = No
> Fast Forward Space File = No
> BSF at EOM = yes
> Backward Space Record = No
> }
Following up on myself here....
If I change conf above to comment out Fast Forward Space File = No then
btape fill succeeds.
Note that previously I'd read in bacula btape docs:
"When I set Hardware End of Medium = no and Fast Forward Space File =
no file positioning was very slow on my LTO-3 (about ten to 100
minutes), but
with Hardware End of Medium = no and Fast Forward Space File = yes, the
time is ten to 100 times faster (about one to two minutes). "
I'm using LTO-2 drive but had waited 3-4 hours w/the Fast Forward Space
File = No setting so figured, perhaps mistakenly, that that should have
been enough??
--
Best regards,
Ken Gunderson
GPG Key -- 9F5179FD
"Never hold discussions with the monkey when the organ grinder is in
the room." - Sir Winston Churchill
-------------------------------------------------------------------------
This SF.net email is sponsored by DB2 Express
Download DB2 Express C - the FREE version of DB2 express and take
control of your XML. No limits. Just data. Click to get it now.
http://sourceforge.net/powerbar/db2/
_______________________________________________
Bacula-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/bacula-users
