On Thu, 4 Dec 2008, Julien Cigar wrote: > I think it's an Ultra, there are only two connectors on it (plus one to > connect to the SCSI card). Actually it's configured as this : > SCSI CARD ====== TAPE DRIVE ====== TERMINATOR
Is the scsi car internally terminated and is the terminator enabled? The cable length includes any cabling inside the tape drive case (usually 10-20cm). > Just to be sure that everything is compatible (as I'm not a SCSI > expert), the tape drive has the following interface : > - Embedded SCSI interface (Ultra160LVD, Single-ended or Low Voltage > differential) That allows U160 or LVD, but your card is U160 so that's what you'll get. > sa0 at isp0 bus 0 target 5 lun 0 > sa0: <SONY SDX-700C 0103> Removable Sequential Access SCSI-2 device > sa0: 40.000MB/s transfers (20.000MHz, offset 8, 16bit) > > I hope everything is compatible (U160 vs SCSI 2 ?) Running U160 devices as FW-scsi is usually unreliable. Get a proper LVD HBA, this will help a lot. AB ------------------------------------------------------------------------- This SF.Net email is sponsored by the Moblin Your Move Developer's challenge Build the coolest Linux based applications with Moblin SDK & win great prizes Grand prize is a trip for two to an Open Source event anywhere in the world http://moblin-contest.org/redirect.php?banner_id=100&url=/ _______________________________________________ Bacula-users mailing list Bacula-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/bacula-users