On Thu, 2012-09-20 at 21:13 +0200, Jan Luebbe wrote: > This is mostly useful during the initial port of barebox to a new > board which is supported by u-boot. It also allows starting barebox > from a SRAM-based u-boot SPL. > > A different load address can be set like this: > make barebox.uimage UIMAGE_BASE=0x80000000 > > Also add barebox.ubl to CLEAN_FILES. > > Signed-off-by: Jan Luebbe <j...@pengutronix.de> > --- > I've carried this patch for some time and adjusted it to support > PBL (compressed image), but have not had an opportunity to verify > it again. > > Teresa, if you have some time to try it out, that would be very > much appreciated. :)
Sascha: As Teresa has tested this, could you apply it? Regards, Jan -- Pengutronix e.K. | | Industrial Linux Solutions | http://www.pengutronix.de/ | Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0 | Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 | _______________________________________________ barebox mailing list barebox@lists.infradead.org http://lists.infradead.org/mailman/listinfo/barebox