On 31/10/2013 16:01, Jean-Christophe PLAGNIOL-VILLARD wrote: > On 14:41 Thu 31 Oct , Renaud Barbier wrote: >> On 30/10/2013 11:34, Jean-Christophe PLAGNIOL-VILLARD wrote: >>>> + barebox_set_model("Unknown"); >>>>> + >>>>> + /* Enable the GPIO Out pins */ >>>>> + out_be32(gur + MPC85xx_GPIOCR_OFFSET, (gpiocr | MPC85xx_GPIOCR_GPOUT)); >>> this should be GPIO API >>>>> + >>>>> + /* Enable NOR low voltage programming (gpio 2) an >> >> Note that here the code enables a CPU function that is, the whole block >> of pins is enabled to be used as GPIO out pin. This does not specify the >> pins direction but the pins function. >> Of course, this can be wrap in a function specific to the CPU. >> > > so this should use pinctrl API > > Best Regards, > J. >>
The pinctrl support seems oriented at enumerating and naming pins as well as controlling pin properties (direction, drive strength,...) on an individual basis. In the code above, it is simply enabling the GPIO out function of the CPU. For controlling individual GPIO pins, you suggestion of using the GPIO API seems the right one to do what I need to do. Thanks. _______________________________________________ barebox mailing list barebox@lists.infradead.org http://lists.infradead.org/mailman/listinfo/barebox