Le Mon, 04 Nov 2013 17:04:46 +0100, "Wjatscheslaw Stoljarski (Slawa)" <wjatscheslaw.stoljar...@kiwigrid.com> a écrit :
> On 11/04/2013 04:07 PM, Eric Bénard wrote: > > Hi Wjatscheslaw, > > > > Le Mon, 04 Nov 2013 16:00:49 +0100, > > "Wjatscheslaw Stoljarski (Slawa)" > > <wjatscheslaw.stoljar...@kiwigrid.com> a écrit : > > > >> On 11/04/2013 01:48 PM, Eric Bénard wrote: > >>> Hi, > >>>> has anyone tried to start barebox on i.MX53 in 11 boot mode (serial > >>>> downloader)? I've tried on Freescale Loco board with pmic da9053, but > >>>> without success. In 00 boot mode (internal boot) works perfectly. U-Boot > >>>> works in both modes. DCD in u-boot and in barebox is the same. Even I > >>>> can turn on LEDs with DCD in 11 boot mode on Loco. > >>>> > >>> works fine here, what are you using to download barebox ? > >> I'm using imx-usb-loader. But I've tried MfgTool from Freescale too with > >> the same result. > >> > > ok sorry it's working here (on a custom board) in 11 boot mode but using > > serial port to load it. IIRC USB was only tested in 00 as a fallback > > when NAND flash is blank. > > > > Eric > Sorry, I forget to mention that I'm using serial downloader via USB. > > Hm... I've just tried to boot u-boot image in 11 mode, and from u-boot > start barebox. And it's works. Why then can I not boot barebox directly? > maybe a clock which is left unitialized (or an IOMUX). Eric _______________________________________________ barebox mailing list barebox@lists.infradead.org http://lists.infradead.org/mailman/listinfo/barebox