Add module identification table.
Tested with a 512M and 1GB module on a JSK dev board.
Signed-off-by: Jason Cobham <[email protected]>
---
arch/arm/boards/ccxmx53/board.c | 92 +++++++++++++++++++++++++++++++++++++++++
dts/src/arm/imx53-ccxmx53.dtsi | 4 +-
2 files changed, 94 insertions(+), 2 deletions(-)
diff --git a/arch/arm/boards/ccxmx53/board.c b/arch/arm/boards/ccxmx53/board.c
index b86648b..f6ba117 100644
--- a/arch/arm/boards/ccxmx53/board.c
+++ b/arch/arm/boards/ccxmx53/board.c
@@ -25,8 +25,47 @@
#include <mach/imx5.h>
#include <mach/generic.h>
#include <mach/imx53-regs.h>
+#include <mach/esdctl.h>
#include <asm/armlinux.h>
#include <mach/bbu.h>
+#include <mach/iim.h>
+
+struct ccwmx53_hwid {
+ u8 variant;
+ u8 version;
+ u32 sn;
+ char mloc;
+};
+
+struct ccwmx53_ident {
+ const char *id_string;
+ const int mem_sz;
+ const char industrial;
+ const char eth0;
+ const char eth1;
+ const char wless;
+};
+
+static struct ccwmx53_ident ccwmx53_ids[] = {
+/* 0x00 - 5500xxxx-xx */ { "Unknown",
0, 0,
0, 0, 0},
+/* 0x01 - 5500xxxx-xx */ { "Not supported",
0, 0,
0, 0, 0},
+/* 0x02 - 55001604-01 */ { "i.MX535@1000MHz, Wireless, PHY, Ext. Eth,
Accel", SZ_512M, 0, 1, 1, 1},
+/* 0x03 - 55001605-01 */ { "i.MX535@1000MHz, PHY, Accel",
SZ_512M, 0, 1,
0, 0},
+/* 0x04 - 55001604-02 */ { "i.MX535@1000MHz, Wireless, PHY, Ext. Eth,
Accel", SZ_512M, 0, 1, 1, 1},
+/* 0x05 - 5500xxxx-xx */ { "i.MX535@1000MHz, PHY, Ext. Eth, Accel",
SZ_512M, 0, 1, 1,
0},
+/* 0x06 - 55001604-03 */ { "i.MX535@1000MHz, Wireless, PHY, Accel",
SZ_512M, 0, 1, 0,
1},
+/* 0x07 - 5500xxxx-xx */ { "i.MX535@1000MHz, PHY, Accel",
SZ_512M, 0, 1,
0, 0},
+/* 0x08 - 55001604-04 */ { "i.MX537@800MHz, Wireless, PHY, Accel",
SZ_512M, 1, 1, 0,
1},
+/* 0x09 - 55001605-02 */ { "i.MX537@800MHz, PHY, Accel",
SZ_512M, 1, 1,
0, 0},
+/* 0x0a - 5500xxxx-xx */ { "i.MX537@800MHz, Wireless, PHY, Ext. Eth,
Accel", SZ_512M, 1, 1, 1,
1},
+/* 0x0b - 55001605-03 */ { "i.MX537@800MHz, PHY, Ext. Eth, Accel",
SZ_1G, 1, 1, 1,
0},
+/* 0x0c - 5500xxxx-xx */ { "Reserved for future use",
0, 0, 0, 0, 0},
+/* 0x0d - 55001605-05 */ { "i.MX537@800MHz, PHY, Accel",
SZ_1G, 1, 1, 0,
0},
+/* 0x0e - 5500xxxx-xx */ { "Reserved for future use",
0, 0, 0, 0, 0},
+/* 0x0f - 5500xxxx-xx */ { "Reserved for future use",
0, 0, 0, 0, 0},
+};
+
+struct ccwmx53_ident *ccwmx53_id;
#define ccwmx53_FEC_PHY_RST IMX_GPIO_NR(7, 6)
@@ -37,6 +76,59 @@ static void ccwmx53_fec_reset(void)
gpio_set_value(ccwmx53_FEC_PHY_RST, 1);
}
+/*
+ * On this board the SDRAM is always configured for 512Mib in dt. The real
+ * size is determined by the board id read from the IIM module.
+ */
+
+static int ccwmx53_devices_init(void)
+{
+ u8 hwid[6] = {0};
+ char manloc = 0;
+
+ if ((imx_iim_read(1, 9, hwid, sizeof(hwid)) != sizeof(hwid)) ||
(hwid[0] < 0x02) || (hwid[0] >= ARRAY_SIZE(ccwmx53_ids)))
+ {
+ printf("Module Variant: Unknown (0x%02x) (0x%02x) (0x%02x)
(0x%02x) (0x%02x) (0x%02x)\n", hwid[0],hwid[1],hwid[2],hwid[3],hwid[4],hwid[5]);
+ memset(hwid, 0x00, sizeof(hwid));
+ }
+
+ ccwmx53_id = &ccwmx53_ids[hwid[0]];
+ printf("Module Variant: %s (0x%02x)\n", ccwmx53_id->id_string, hwid[0]);
+
+ if (hwid[0]) {
+ printf("Module HW Rev : %02x\n", hwid[1] + 1);
+ switch (hwid[2] & 0xc0) {
+ case 0x00:
+ manloc = 'B';
+ break;
+ case 0x40:
+ manloc = 'W';
+ break;
+ case 0x80:
+ manloc = 'S';
+ break;
+ default:
+ manloc = 'N';
+ break;
+ }
+ printf("Module Serial : %c%d\n", manloc, ((hwid[2] & 0x3f) <<
24) | (hwid[3] << 16) | (hwid[4] << 8) | hwid[5]);
+ printf("Module RAM : %dK\n", (ccwmx53_id->mem_sz)/1024);
+ if ((ccwmx53_id->mem_sz - SZ_512M) > 0)
+ {
+ arm_add_mem_device("ram1", MX53_CSD0_BASE_ADDR+SZ_512M,
ccwmx53_id->mem_sz-SZ_512M);
+ }
+ } else {
+ return -ENOSYS;
+ }
+
+ ccwmx53_fec_reset();
+
+ armlinux_set_architecture(MACH_TYPE_CCWMX53);
+
+ return 0;
+}
+device_initcall(ccwmx53_devices_init);
+
static int ccxmx53_reg_init(void)
{
unsigned char value = 0;
diff --git a/dts/src/arm/imx53-ccxmx53.dtsi b/dts/src/arm/imx53-ccxmx53.dtsi
index c89a093..5ca177b 100644
--- a/dts/src/arm/imx53-ccxmx53.dtsi
+++ b/dts/src/arm/imx53-ccxmx53.dtsi
@@ -17,8 +17,8 @@
compatible = "digi,imx53-ccxmx53", "fsl,imx53";
memory {
- reg = <0x70000000 0x20000000>,
- <0xb0000000 0x20000000>;
+ device_type = "memory";
+ reg = <0x70000000 0x20000000>;
};
};
--
1.9.1
_______________________________________________
barebox mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/barebox
