On Wed, Nov 23, 2011 at 2:55 PM, Jeremy McSpadden <[email protected]> wrote: > tail -f /var/log/maillog ... look for errors. If there are no errors. Start > removing each item one by one. Take mailscanner/baruwa out of the loop. Make > sure postfix is delivering without anything else. Check permissions on your > incoming directories. Process of elimination. > > > -- > Jeremy McSpadden > On Nov 23, 2011, at 2:52 PM, "[email protected]" <[email protected]> > wrote: > > Dear Jeremy, > > I changed debug = no to debug = yes and restarted mailscanner. But not > getting any error log. > > Will you please guide further for the same? > > Thanks, > > > On Thu, Nov 24, 2011 at 2:01 AM, Jeremy McSpadden <[email protected]> > wrote: >> >> Debug >> >> >> -- >> Jeremy McSpadden >> On Nov 23, 2011, at 2:31 PM, "[email protected]" <[email protected]> >> wrote: >> >> Yes i did. Still same issue. >> >> Even I did debug mode. But not getting anything. >> >> Nov 23 14:28:26 mx MailScanner[9766]: Batch (1 message) processed in 16.20 >> seconds >> Nov 23 14:29:10 mx MailScanner[9732]: Batch (1 message) processed in 17.54 >> seconds >> Nov 23 14:29:14 mx MailScanner[9766]: Batch (4 messages) processed in >> 47.91 seconds >> Nov 23 14:29:27 mx MailScanner[9651]: Batch (2 messages) processed in >> 32.18 seconds >> >> >> really bad results. >> >> >> On Thu, Nov 24, 2011 at 1:57 AM, Jeremy McSpadden <[email protected]> >> wrote: >>> >>> Have you rebooted the server for good measure ? >>> >>> >>> -- >>> Jeremy McSpadden >>> >>> On Nov 23, 2011, at 2:25 PM, "[email protected]" >>> <[email protected]> wrote: >>> >>> > No we have not updated or added any other rules. It was behaving like >>> > this since last 10 hours. >>> > >>> > Earlier it was working fine without any issue >>> >>> _______________________________________________ >>> Keep Baruwa FREE - http://pledgie.com/campaigns/12056 >> >> >> >> -- >> Kind regards, >> Dhaval Soni ( RHCA ) >> >> Active Contributor of LinuxArticles.org >> >> _______________________________________________ >> Keep Baruwa FREE - http://pledgie.com/campaigns/12056 >> >> _______________________________________________ >> Keep Baruwa FREE - http://pledgie.com/campaigns/12056 >> > > > > -- > Kind regards, > Dhaval Soni ( RHCA ) > > Active Contributor of LinuxArticles.org > > _______________________________________________ > Keep Baruwa FREE - http://pledgie.com/campaigns/12056 > > _______________________________________________ > Keep Baruwa FREE - http://pledgie.com/campaigns/12056 > >
Here are some general MailScanner troubleshooting steps: - Stop MailScanner (service mailscanner stop) then run "MailScanner --debug --debug-sa" to see where the problem might be. - Check your Virus Scanners. If using clamav, only use clamd and not clamav module in MailScanner.conf. - Check your DNS servers in /etc/resolv.conf. It is recommended to install a local caching DNS server and set your /etc/resolv.conf to "nameserver 127.0.0.1" for high volume servers. - Run "spamassassin -D --lint" and check all of the times to see if the delay is in SpamAssassin. Google around a bit and you will find information from the MailScanner mailling list on this topic. _______________________________________________ Keep Baruwa FREE - http://pledgie.com/campaigns/12056
