Andrew J. Barr wrote: > On 7/31/07, Richard Jonsson <[EMAIL PROTECTED]> wrote: >> When 0-4 meters away from AP I get a steady rate of 18.5Mbps with iperf. When >> walking further away the transmission stops completely. This is when module >> is loaded and interface brought up next to the AP. I then get 54Mbit >> connection. >> >> When loading the module from 5 metres away I get 1Mbit connection which is >> not >> very stable, but still usable. >> >> Rate doesn't seem to change when signal drops. If it were I'm sure bcm4301 >> would be on par or better than the driver for that other os. > > Same here, BCM4306, Apple PowerBook G4 17". > > It works great until I get more than a few yards away, then...nothing. > Please enter the command 'echo 1 > /sys/kernel/debug/bcm43xx/phyX/debug_xmitpower', where X is the correct value. It will start at 0 when just booted and increase by 1 each time the modules is reloaded. Send me the TX power output from dmesg.
Larry _______________________________________________ Bcm43xx-dev mailing list [email protected] https://lists.berlios.de/mailman/listinfo/bcm43xx-dev
