On Sunday 16 September 2007 12:17:50 Marcin Kosiba wrote: > On Sunday 16 September 2007, Michael Buesch wrote: > > On Sunday 16 September 2007 11:26:21 Marcin Kosiba wrote: > > > On Sunday 16 September 2007, Larry Finger wrote: > > > > The only switch associated with any of the BCM cards that I know about > > > > is the radio-enable switch. If that is what you need, it can only be > > > > controlled externally. The software can read its state, but not control > > > > it. > > > > > > not fun - oh well... gotta warm that soldering iron up then... > > > > > > > What OS are you using? If Linux and the appropriate driver is > > > > installed, the output of the dmesg command will show some details. > > > > > > slackware linux 12.0 > > > (uname -a: > > > Linux ebox 2.6.21.5 #2 Tue Jun 19 15:22:48 CDT 2007 i586 05/00 SiS SiS > > > SiS GNU/Linux) > > > > > > dmesg | grep bcm > > > > > > bcm43xx: Chip ID 0x4306, rev 0x3 > > > bcm43xx: Number of cores: 5 > > > bcm43xx: Core 0: ID 0x800, rev 0x4, vendor 0x4243 > > > bcm43xx: Core 1: ID 0x812, rev 0x5, vendor 0x4243 > > > bcm43xx: Core 2: ID 0x80d, rev 0x2, vendor 0x4243 > > > bcm43xx: Core 3: ID 0x807, rev 0x2, vendor 0x4243 > > > bcm43xx: Core 4: ID 0x804, rev 0x9, vendor 0x4243 > > > bcm43xx: PHY connected > > > bcm43xx: Detected PHY: Analog: 2, Type 2, Revision 2 > > > bcm43xx: Detected Radio: ID: 2205017f (Manuf: 17f Ver: 2050 Rev: 2) > > > bcm43xx: Radio turned off > > > bcm43xx: Radio turned off > > > > > > as I've said - off :/ > > > > What about bringing the device up? > > ok, my bad - had the wrong firmware version up there (seems as though the > error messages are shown in dmesg only if I load the module manually - if it > is loaded on startup they probably go somewhere else..) > > bcm43xx: Radio turned off > bcm43xx: Radio turned off > bcm43xx: PHY connected > bcm43xx: Microcode rev 0xf5, pl 0x5a (2003-12-22 20:11:25) > bcm43xx: Radio turned on > bcm43xx: Radio enabled by hardware > bcm43xx: Chip initialized > bcm43xx: 30-bit DMA initialized > bcm43xx: Keys cleared > bcm43xx: Selected 802.11 core (phytype 2)
So everything's fine? -- Greetings Michael. _______________________________________________ Bcm43xx-dev mailing list Bcm43xx-dev@lists.berlios.de https://lists.berlios.de/mailman/listinfo/bcm43xx-dev
