Ehud Gavron wrote: > First, thanks for making the LED light up again, Larry and Michael. > > If I use the kill-switch both the WiFi and the BT LEDs go off. > When I switch back on the BT LED lights but the WiFi does not. > Dmesg shows: > Dec 16 17:43:30 egdell kernel: input: b43-phy0 as /class/input/input11 > Dec 16 17:43:31 egdell kernel: Registered led device: b43-phy0:tx > Dec 16 17:43:31 egdell kernel: Registered led device: b43-phy0:rx > Dec 16 17:43:31 egdell kernel: Registered led device: b43-phy0:radio > Dec 16 17:43:31 egdell kernel: ADDRCONF(NETDEV_UP): wlan0: link is not ready > Dec 16 17:44:17 egdell kernel: ADDRCONF(NETDEV_CHANGE): wlan0: link > becomes ready > Dec 16 17:44:45 egdell kernel: usb 1-2.4: USB disconnect, address 4 > Dec 16 17:44:45 egdell kernel: b43-phy0: Radio hardware status changed > to DISABLED > Dec 16 17:44:49 egdell kernel: b43-phy0: Radio turned on by software > Dec 16 17:44:49 egdell kernel: b43-phy0: The hardware RF-kill button > still turns the radio physically off. Press the button to turn it on. > Dec 16 17:44:58 egdell kernel: usb 1-2.4: new full speed USB device > using ehci_hcd and address 6 > Dec 16 17:44:58 egdell kernel: usb 1-2.4: configuration #1 chosen from 1 > choice > Dec 16 17:44:58 egdell kernel: b43-phy0: Radio hardware status changed > to ENABLED > Dec 16 17:45:01 egdell kernel: ADDRCONF(NETDEV_CHANGE): wlan0: link > becomes ready > Dec 16 17:45:02 egdell kernel: ADDRCONF(NETDEV_CHANGE): wlan0: link > becomes ready > > Reloading b43 (modprobe -r b43 && modprobe b43) restores the WiFi LED. > > Having glanced at Michael's last patch to avoid the race condition... I > know that code is beyond me.
As long as you are using the latest "everything" branch wireless-2.6, and rfkill-input is built for your system, it would seem that KEY_WLAN (238) is not the code needed to turn your radio LED on. Is it possible for you to check that out? Larry _______________________________________________ Bcm43xx-dev mailing list Bcm43xx-dev@lists.berlios.de https://lists.berlios.de/mailman/listinfo/bcm43xx-dev