Hi, I am using Beaglebone black. It does not boot if I power it up using the miniUSB or adapter. The power led just flashes for a moment and then it goes off. If I press the power button it is just the same: a short flash of the LED, then silence. This thing happened while a GPIO pin was connected to base of transistor via 10k resistor, we were testing the GPIO pins.
Searching on BBB forums, I decipher, it means that an excess current flow was detected and the PMIC has shut down. Is there any way to turn it on? -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to beagleboard+unsubscr...@googlegroups.com. For more options, visit https://groups.google.com/groups/opt_out.