There are also *many* low cost M0+, M3, and M4 dev boards out there. Not to mention the MSP430 launchpad. Some of the NXP MCUs can even be used with very minimal external circuitry to get them up and running, Something like one resistor and one capacitor, if memory serves correctly Other MCU's such as the MSP430G2553 are very low power, can operate between 1-16Mhz, and can do I2C, UART, and SPI in hardware. Among other things.
*OR* one could just buy a "proper" 1-wire / I C sensor . . . On Fri, Jan 16, 2015 at 11:59 AM, <k...@cranehome.info> wrote: > Alternatively, use an Arduino to manage the I2C butchering device and get > your data from the Arduino. Honestly I wish these psudo-I2C devices were > driven out. There is a protocol for a reason. > > -- > For more options, visit http://beagleboard.org/discuss > --- > You received this message because you are subscribed to the Google Groups > "BeagleBoard" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to beagleboard+unsubscr...@googlegroups.com. > For more options, visit https://groups.google.com/d/optout. > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to beagleboard+unsubscr...@googlegroups.com. For more options, visit https://groups.google.com/d/optout.
