Hi all. I am developing a control system which uses GPIO to perform IO operations and control peripherals. So, right now, I have a DTS file which initializes all GPIOs that I am going to use, mostly outputs. It compiles and loads normally. Here it is: http://pastebin.com/HTB0v8dH I previously thought that it would initialize the GPIO_OE registers, since it is being configured as output, but apparently it does not. So, I was wondering how could I create a DTS file that would initialize both GPIO_OE register and set the initial value for it. Any thoughts on that? Thanks in advance! Paulo Sherring.
-- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to beagleboard+unsubscr...@googlegroups.com. To view this discussion on the web visit https://groups.google.com/d/msgid/beagleboard/56681858-5d87-465f-97ce-5a729a4806ae%40googlegroups.com. For more options, visit https://groups.google.com/d/optout.